Wetsuit thickness for Lebanese water by season
Approximate sea temperature month by month on the Lebanese coast, the open cell suit thickness that goes with it, and how to fit and care for the suit.
Published by Elite Diving School
Freedivers get cold faster than scuba divers. You spend long minutes still on the surface between dives, and breath hold makes the body pull blood away from the skin. A suit that feels warm enough for a swim can leave you shivering after an hour of training, so we choose thickness by the water temperature and the time you will spend in it.
Sea temperature on the Lebanese coast, month by month
The figures below are approximate surface temperatures near the coast. They move by a degree or two from year to year, and a windy week can cool the water quickly. Below the surface it is often colder, especially in early summer, when a sharp drop in temperature (a thermocline) can sit a few metres down.
| Months | Sea temperature | Suggested open cell suit |
|---|---|---|
| January to March | 17 to 18 °C | 5 mm, or 7 mm for long sessions and divers who feel the cold |
| April to May | 19 to 22 °C | 5 mm in April, 3 mm from late May for most divers |
| June | 24 to 26 °C | 3 mm |
| July to September | 27 to 30 °C | 1.5 or 2 mm, or 3 mm for long or deep sessions |
| October to November | 22 to 25 °C | 3 mm, moving to 5 mm by late November |
| December | 19 to 20 °C | 5 mm |
Adjust for how you dive
- Go one step thicker for long sessions, depth training below the thermocline, or spearfishing, where you can stay in for hours.
- Go one step thicker if you are lean or tend to feel the cold. People differ more than the table can show.
- Go thinner only for short, active swims in warm water, where overheating on the surface is the real risk.
If you dive all year, a 3 mm and a 5 mm suit cover most of it. Add a 7 mm for winter if you stay in for long hours, and a thin suit if you dive mostly in high summer.
Why open cell
An open cell suit has bare neoprene on the inside. It grips the skin, so very little water gets in and moves around, and that thin layer of still water is what keeps you warm. A lined suit of the same thickness lets more water flush through every time you move. The outside is usually covered in nylon for strength, or left as smooth skin, which is lighter and faster but scratches more easily.
Neoprene compresses with depth, so a 5 mm suit is thinner and less buoyant at 20 m than on the surface. When you change to a thicker or thinner suit, check your weighting again at the surface before you dive.
Fit
A freediving suit should fit closely everywhere, with no gaps at the lower back, the armpits or the neck. Gaps fill with water, and the water moves each time you kick. The hood should seal around your face without pressing on your throat. A suit that is snug but lets you breathe deeply when you stand still is about right. Two piece suits, a hooded jacket with high waisted trousers, are the usual choice because the overlap around the waist adds warmth where you need it most.
Putting it on and looking after it
Putting it on
Open cell neoprene will not slide over dry skin. Use a lubricant: a wetsuit lubricant, or a mix of water and a mild, unperfumed conditioner or soap in a bottle. Pour some inside the suit and on your skin, then ease it on gently. Use the pads of your fingers, never your fingernails, because a nail will cut open cell neoprene easily.
After the dive
- Rinse the suit in fresh water after every dive, inside and out.
- Dry it inside out in the shade, then turn it the right way out to dry the outside. Direct sun breaks neoprene down.
- Hang it folded over a wide hanger, or lay it flat. A thin wire hanger leaves a crease that does not come out.
- Do not machine wash it, tumble dry it or leave it in a hot car.
- Close small cuts early with neoprene glue before they grow into tears.
Find it in the shop
Browse what we have in stock, or send us your question and we will answer on WhatsApp.